Chapter 5: Preparing for installation
Testing system components
Page 5-9
Equipment to Be
Installed
Tools Required
AP or BHM or BHS
Antenna
13 mm Spanner Wrench (or Ratchet Spanner Wrench) Pair
Used for connecting the antenna (sector or omni for AP, or directional for
BH)base to the pole/mast mounting bracket
Self-amalgamating and PVC Tape
Used for weatherproofing N-type connections
N-type Torque Wrench (not required but recommended)
Used for assuring proper tightening of N-type connectors terminating the
RF cables
SM
Wrench/driver (depending on operator’s choice of clamps)
Used for tightening clamps to the pole
Alignment tone adapter / headset
Used for aligning the SM to the AP
Universal Global
Positioning System
Philips Screwdriver
Used for attaching the UGPS unit to the pole/mast mounting bracket
13mm Spanner Wrench (or Ratchet Spanner Wrench)
Used for connecting the mounting bracket’s U-bolt to the antenna or mast
Cabling
Electrician’s Scissors or Wire Cutters
Used for cutting wire to length
RJ-11/RJ-45 Crimping Tool
Used for stripping RJ-11/RJ-45 cables and for terminating cable ends
Cable Testing Device
Used to ensure that cables are properly constructed
Standards for Wiring
Modules automatically sense whether the Ethernet cable in a connection is wired as straight-
through or crossover. Operators may use either straight-through or crossover cable to connect a
network interface card (NIC), hub, router, or switch to these modules. This guide follows the
EIA/TIA-568B colour code standard.
Содержание PMP 450d Series
