36
/ 55
Commands
The button
COMMANDS
allows the user to introduce different setpoints:
Voltage setpoints
Current setpoints
Active power setpoints
Once again, this function is only permitted when the Control variable is set to LCD. Information
about the different kinds of setpoints that the user can introduce through the touchscreen can
be found below. When the
COMMANDS
button is pressed, the following keyboard will appear.
The kind of setpoint to introduce will depend on the operation mode (Constant Voltage,
Constant Current or Constant Power) and the connection mode (Independent or Parallel).The
procedure to send a setpoint consists of the following steps:
1.
Press
COMMANDS
button.
2.
Introduce the first setpoint and press
Enter
.
3.
Introduce the second setpoint and press
Enter
.
4.
Introduce the third setpoint and press
Enter
.
5.
Press
SEND
button.
If the user needs to erase the current setpoint being edited, the
Cancel
button (grey one) sets
it to zero.
