User Manual – Rev B
FCS Series II
4.3 Output Programming
4.3.1 Set the Output
Output parameters are all set from the PROGRAM screen.
1. Use the MENU key and select the PROGRAM entry.
2. Press the ENTER key to bring up the PROGRAM menu.
or
2. Use the PROG key to directly bring up the PROGRAM menu.
There are two methods for programming output parameters:
IMMEDIATE
mode
SET
mode
4.3.2 Slewing Output Values with the Knob in IMMEDIATE Mode
The default mode of operation is an immediate mode in which changes to output parameters
made with the knob or the entry keypad are immediately reflected at the output.
To change the output voltage:
Counter
Clock
wise
Clock
wise
INCR
DECR
1. Place the cursor on the VOLT entry
2. Rotate the shuttle knob clockwise to increase the value, counterclockwise to decrease the
value or use the Keypad to enter a value and press the Enter key.
These changes take effect immediately.
To change the output frequency:
Counte
Clock
wise
r
Clock
wise
INCR
DECR
1. Place the cursor on the FREQ entry
2. Rotate the shuttle
knob clockwise to increase the value, counterclockwise to decrease the
value or use the keypad to enter a value and press the Enter key.
These changes take effect immediately.
California Instruments
75
Содержание FCS Series II
