![background image](http://html1.mh-extra.com/html/california-instruments/fcs-series-ii/fcs-series-ii_user-manual_3475047068.webp)
User Manual – Rev B
FCS Series II
4.2.9 CONFIGURATION Menu
uch as the
The configuration menu may be used to configure various aspects of the instrument s
serial port, IEEE-488/GPIB address and the power-on settings of the supply.
ENTRY
DESCRIPTION
ADDRESS
0 - 31
Sets the selected IEEE / GPIB bus address for the
ss 0
PIB
optional IEEE/GPIB interface.
Factory default is address 1. The left knob
(
Voltage
) can be used to scroll through the 0
through 31 address range. Do not use addre
as this address is typically reserved for the G
controller.
BAUD RATE
600
19200
57600
115200
rial
communications port. The same setting applies to
the
terface of the power source.
.
rate to
d to scroll through
9
38400
230400
460800
Sets the baud rate for the RS232C se
the internal baud rate used to interface with
USB and LAN in
Factory default is 38400 baud. Available settings
are 9600 through 460800 baud for RS232C
Note:
For USB use, you must set the baud
460800. For LAN use, any baud rate can be used
but 460800 is recommended.
Either shuttle knob can be use
these selections.
POWER ON
REG0
recalled
(RST).
tory
Note that to use REG0 for power-on default, the
contents of the register must be programmed first.
See section 4.2.8. If an empty register is selected,
the power source will revert back to RST (factory
setting).
RST
Selects either non-volatile REG0 to be
automatically at power-on or factory default
Factory default is RST, which recalls the fac
settings.
CONTROL MASTER
AUX
This is an information-only field that displays the
controller operation mode. For a single stand-alone
unit, the mode is always MASTER.
Alternatively, the auxiliary mode may be detected if
the system interface cable at the rear panel is
plugged in and connected to another FCS unit. In
AUX mode, the AC source is controlled by another
California Instruments
68
Содержание FCS Series II
