California Instruments FCS Series II, Руководство пользователя

Страница: 64 / 210

User Manual – Rev B FCS Series II
4.2.7 TRANSIENT Menu
e n a time control
Each step in these lists is assigned a sequence number ranging from #0 through #99. The
nu
determines the h ea
Each step can control the voltage setting, vo w
rate and dwell time. The dwell time determin tep
before progressing to the next step. Dwell times can range from 1 msec up to 900000 secs.
Transient lists can be set up from the front p the bus. The transient list can be saved
with the rest of the front panel settings in one
The transient menu is used to program and execute user-defined output sequences. These
output sequences are defined as a sequential list of voltage and/or current settings that can be
xecuted i led manner.
mbering order in whic ch step is executed.
ltage slew rate, frequency setting, frequency sle
es how long the output dwells at the current s
anel or over
of the setup registers. (See Register Menu).
ENTRY DESCRIPTION
TRAN ST Indicates the sta
operation are:
tus of the transient system. Available modes of
IDLE Transient system is in IDLE or inactive state. To
start a transient list, press the ENTER key while on
the TRAN STATE field. Note that the output must be
ON to run a transient program or an error message
will be displayed.
WTRIG Transient system is
e armed and waiting for a trigger
vent.
BUSY T xecution
is in progress.
ransient system is active. A transient list e
COUNT Sets the execut
indicates the transient will run 1 times. The count value can be set
with either voltage or current knob while the cursor is on this field.
The count range is from 1 through 2E+08. Values below 200,000
are displayed in fixed point notation. Value higher than 200,000
are displayed as a floating point number (2E+05). The display has
insufficient characters to display the entire mantissa so entering
values above 2E+05 from the keyboard is not recommended.
ion count for the transient system. A count of 1
TRIG SOURCE Indicates the trigger source for transient system. Available trigger
sources are:
IMM Immediate mode. The transient is started from the
front panel using the ENTER key
California Instruments 64