![background image](http://html1.mh-extra.com/html/california-instruments/fcs-series-ii/fcs-series-ii_user-manual_3475047020.webp)
User Manual – Rev B
FCS Series II
2.5 Special Features
Controller Features
Mode: Switches
between 1 and 3 phase outputs.
Parallel Operation:
FCS36 and FCS54 systems use two or three chassis in parallel
operation. The two or three chassis must be connected using the system
interface cable supplied with the system.
Controller:
Programmable controller front panel assembly.
Output Relay:
Standard output relay feature to isolate power source from the load.
Output On/Off:
The output relay can be used to quickly disconnect the load. A yellow
status indicator displays the status of the output relay. Relay is either
through front panel button or using Remote Inhibit input signal.
External Trigger Output
or Function Strobe
An external TTL output is available which may be used to trigger other
equipment. The TTL output can be controlled by the transient
programming system. This requires the trigger mode to be set to EXT
(factory default). This can only be done over the bus using the
OUTP:TTLT:MODE TRIG command.
It can also be configured to generate an output pulse any time the
voltage, frequency, current limit or phase programming is updated. This
requires the trigger mode to be set to FSTR. This can only be done over
the bus using the OUTP:TTLT:MODE FSTR command. This mode is
compatible with the CI FCS Series I.
The Trigger Output / function strobe is an active low TTL signal with a
duration of no less than 400 usec.
Clock and Lock Mode
Enables two or more independent FCS II power systems to be phase
synchronized to each other. One system (-LKM) acts as the master, the
other(s) (-LKS) as auxiliaries. The –LKS units are synced to the –LKM
unit. Refer to section 3.9 for details on Clock and Lock mode.
Trigger Input
A TTL input signal may be used as an external trigger source for output
changes programmed on the AC power source transient system. This
requires the trigger source to be set to EXT. This can only be done over
the bus.
California Instruments
20
Содержание FCS Series II
