INNOVATION TOTAL LITE Rev. 11 05/2018
75
www.cafection.com 800-561-6162
SERVICE & INSTALLATION MANUAL for Innovation Series’ Total Lite
P
a
rt
s Ma
in
te
na
nc
e
9.3
Brew Group Assembly
Removing the brew group
1. Open the main door.
2. Go in service mode by pressing SW1 white button (See
section 4.15).
3. Select change filter paper once.
4. Wait for the brew chamber to open. Cut the filter paper.
5. Remove the coffee spout and the hose support bracket
from the right side of the brewer assembly.
6. Support the brewer assembly by holding the aluminum
frame on the right side of the brewer assembly.
7. With your left hand, slide the retaining pin over to the right
and then down.
8. Pull the brewer assembly straight towards
you.
Installing the brew group
1. Make sure that the dog drive pin in the back of the
brewer is at 1 o’clock.
2. Align the left edge of the brewer on the left bracket
support.
3. Push the brewer back completely into the dog drive
motor.
4. Slide the brewer’s retaining pin up and then left.
To clean the coffee brew group, see section 7.7.3.
Pin
Dog drive
8.
7.
