Cabletron Systems CoreWatch, Руководство пользователя

Страница: 468 / 495

Appendix D: Error Messages
468 CoreWatch User’s Manual
This error message is generally indicative of some network problem or other error that
puts CoreWatch in the wrong state. CoreWatch sometimes displays this message if you try
to log in and the SSR did not clean up an earlier session because it was busy. Normally,
however, this should not occur.
Solution:
If the operation you are attempting needs a login, restart CoreWatch.
Another user at <IP address> is currently configuring the Switch. If you terminate
that session the other user will lose all changes which have not been committed. Do
you wish to end the other users session?
Indicates that you tried to log in to Configuration Expert while another user is already
running CoreWatch in the Privileged mode to configure the SSR.
Solution:
Specify whether you want to terminate the other user’s session by clicking either the Yes
or No button. If you click No the other user’s session will not be terminated and
Configuration Expert is not started. Clicking Cancel closes the error message.
At least one ‘Port’ must be added to continue.
You have not added a port to an object that requires at least one port.
Solution:
Add a port to the object.
Cannot connect to switch
Indicates that the SSR could not be reached when you tried to log in. This could be
because of bad connection, the SSR is not on, or another such problem.
Solution:
Check whether the machine is reachable by sending a ping packet. Also verify that you
have entered the correct community string and log in password. Then try logging in
again.
Cannot display an empty report
Indicates that CoreWatch cannot generate a report because the table associated with that
report is empty.
Solution:
Generate the report after the table contains some data.