C-COM Satellite iNetVu, Руководство по обслуживанию, Страница: 71 / 109

iNetVu™ Service Manual Page 71 of 109
4.8. Installing Reflector to iNetVu™ 1200 Mobile Platform
If this is the first time working with the iNetVu™ Mobile
Platform it is highly recommended that you read the entire
manual to familiarize with the proper procedure for
connecting the cables to the controller and iNetVu™
software operation.
Required Materials:

1.2m Reflector

1200 Mobile Platform Rev. 2.3+

2 Ball Joint Gas-shock Springs

Reflector Assembly Hardware Bag

Phillips Screwdriver

10mm (3/8”) Wrench

13mm (1/2”) Wrench

Handheld Controller (Optional)
Procedure:
Use the following steps to attach a 1.2m Reflector to an iNetVu™ 1200 Mobile Platform
Rev. 2.3:
1)
Remove reflector from crate and any packing materials on the Mobile Platform.
2)
Raise the Mobile Platform to approximately 30

using the iNetVu™ Mobile
Software or the Handheld Controller. For more information regarding the use of
the iNetVu™ Mobile Software and its installation, please refer to the iNetVu™
System Manual.
3)
Peel back the Reflector Back Cover at the base of the Reflector to expose the
Gas Spring Bracket mounting holes.
Fig. 29: Exposed Gas Spring Bracket Mounting Holes
4)
Attach Gas Spring Brackets to each side of the Reflector using a Phillips
Screwdriver and 10mm (3/8”) Wrench.