Byzoo SJ01, Руководство пользователя

Страница: 10 / 58

My juicer does not
operate when the
switch is in the ON
position
My juicer has stopped
during operation
The Hopper will not
open
Trou bleshooti ng
l. Make sure the power card is properly secured into the power
source and that the switch is turned to the 'ON' position.
2. Check that the Hopper is assembled correctly.
PLEASE NOTE: lf the Hopper has not been securely locked in
place with the arrows aligning, the appliance will not work for
safety reasons. This is due to a magnetic safety strip located
inside the hopper which must align with the matching
magnetic strip inside the base.
3. Check the juicer has been assem bied according to the
instructions in this manual.
lf your juicer has stopped du ring operation, please check that
the hopper is correctly aligned with the base. lf the alignment
shifts du ring operation the juicer will simply turn off. Turn your
juicer
off,
reset the hopper and you should be able to continue.
The B y z oo Juicer has an automatic motor cut
off
safety feature
that will activate if the juicer is overloaded. This has been
designed to help prevent accidental damager and to help
extend the life of the machine. To reset your juicer take
off
the
Hopper lid and remove any ingredients in the juice bowl. lf
necessary switch the juicer into Reverse/ REV to unwind any
fibre that is caught around the auger.
The Hopper opens in an anti-clockwise way.
lf the Hopper will not open easily, try the following:
l. Allow your B y z oo Juicer to run without adding more
ingredients before turning
off
and attempting to remove the
Hopper.
2. Switch your juicer into reverse for a few moments to help
dislodge any remaining ingredients around the auger and
feeding chute of the Hopper.
PLEASE NOTE: The auger turns in a clockwise direction which
is opposite of the Hopper. This may cause an unintentional
tightening of the Hopper and result in difficulty releasing the
hopper from the ju icing bowl.
3. After you have fed the last ingredients into the Hopper, let it
run until all the juice and pulp has run through the machine.
Pour one or two glasses of water down the Hopper to flush out
much of the left over pulp.
4. Lift
off
the entire ju icing section before trying to separate.