2019/08 - Indice de révision : D - Code : 29650
TRAITEMENT DE L'EAU
47/72
Open the control box lid to make sure the unit is turned OFF.
It is recommended to wear rubber or polyethylene protective gloves and safety glasses. It is also
advisable to protect your clothes.
Make sure the pool's machine room is properly vented to avoid damage from acid vapors.
Under no circumstances should the machine room be used to store equipment, furniture, sports gear
or any other equipment that is not related to the pool, including spare acid containers. The machine
room must be aired and vented prior to entering it.
Acid container must be stored inside a spill containment vessel (a basin to hold acid in case of
overflow or tipping of the acid container).
4.5.3 Procedure
•
Determine the location where you wish to install the acid pump on the wall.
•
Check that the all components: electrical wiring, tubes etc. reach their position.
•
Drill and attach the acid pump's clip to the wall and hang the pump on it.
•
Open the control box service panel.
•
Find the acid pump connection point marked "acid pump". Insert the signal cable that originates from the
pump through the hole at the bottom of the control box and connect it to the acid pump terminal. Make sure
the cable is secured and put the panel cover back in position.
•
Connect the electrical cable of the acid pump to the main power source in the machine room (240V) parallel
to the circulation pump. This must be performed by a licensed electrician!
•
Establish the pipe diameter you have installed and make sure you have the correct pipe saddle (50 or
63mm).
•
The saddle clamp for the acid pump must be installed on the pipe right after the electrolysis cell.
•
Select the point where the acid will be injected, and drill a 9mm hole in the pipe.
