30
Connect the ground wire on the bell housing to the green terminal block on the casting. Push
the bell housing and the lock ring up until it covers the ceiling plate. Tighten the two set
screws on the lock ring using a 3/32 in. Allen key.
7.0 Extension/Spring Arm
-
Wall and Ceiling Assembly
Place Extension/Spring Arm onto a flat surface before continuing with following steps. Locate
the plastic bag, secured to the arm, containing hardware kit.
Figure 38: Orientation of Extension/Spring Arm.
To head unit
To down tube
A
B
Elbow with
cover removed
Figure 37: Ceiling bell housing assembly.
6.10 Ceiling Bell Housing Assembly
Assembly Instructions:
1.
Remove the elbow cover from one end (
A
) of the Extension/Spring Arm. For detailed
instructions on how to remove cover, refer to table of contents for
“
Elbow cover removal
instructions
”.
Set the covers aside.
2.
Remove green plug (
B
) from end of the spring arm as follows:
Tighten the two set
screws on the lock ring
Содержание AIMLED070 Series
