Burton AIMLED070 Series, Руководство по установке

Страница: 33 / 44

33
Part # Qty Description
A 1 Extension/Spring Arm Assembly
B 1 Wall/Ceiling mount down tube
C 2 Slip Ring Screws
D 1 Safety Washer
E 1 Retaining Ring Washer
F 2 Retaining Rings
Figure 44: Extension/Spring Arm assembly.
A B
C
E
D
F
Electrical Connector (Slip ring)
Internal tab on the safety
washer to go through the
bottom hole on the shaft.
6. Install the retaining ring washer, then install the safety washer with the notch facing into
the hole, and finally snap the two retaining rings into the groove. Refer to Figure 44.
WARNING: It is critical that the retaining rings and washers be installed in
given order per Step 6 and Figure 44. Disregarding this instruction can
present the risk of serious or fatal injury.
WARNING: It is critical that the retaining rings are fully seated inside the
down tube shaft ’ s groove. Disregarding this instruction can present the risk
of serious or fatal injury.
Order of Retaining
Ring Assembly
WARNING: It is critical that the safety washer tooth is properly inserted into
the hole of the down tube shaft to avoid a potential safety hazard. The
safety washer acts as a secondary safety support in the case that both
retaining rings fail.