26
Slip the locking ring (
A
) and the bell housing (
B
) onto the down tube.
NOTE: This illustration above is for single ceiling version, and only one power supply
is shown.
Assemble the down tube by sliding it up center hole in the ceiling casting. Position the tube
so that the lower hole (
A
) in the down tube is aligned with upper hole (
B
) of the ceiling
casting. Use thread locker (Loctite or similar) on screws to prevent them from becoming
loose. First fasten the upper set screw, which is a dog point screw. Make sure it fully
engages the hole of the down tube. Next fasten lower set screw, refer to Figure 33A.
Figure 32: Ceiling down tube assembly.
Figure 33A: Ceiling casting to down tube assembly.
B
A
A
B
Содержание AIMLED070 Series
