BURNiT Pell Easy 20, Инструкция по установке и эксплуатации

Страница: 5 / 48

5
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
Table 1.
Electricity consumption of the boiler
Maximum electrical input
360 W
Electrical input at nominal heat
output
70 W
Electrical input at minimum
heat output
45 W
1.2.2. Instructions to installation user
$
DANGER of intoxication or
explosion
Toxic gases may be discharged
when burning waste, plastics,
liquids.
- Use only the fuels indicated in
this manual.
- In case of danger of explosion,
ignition or discharge of exhaust
gases in the room, stop the pellet
burner from operation.

Customer must undergo boiler
operation/maintenance training
by authorized installer/service
shop.

CAUTION! Danger of injury
/ damage of system due to
incompetent operation.
- The boiler must be serviced only
by persons familiar with the
operation manual.
- As user, you are only allowed to
start the boiler up, adjust the
temperature of the boiler, shut
the boiler down and clean it.
- Unattended children must not be
allowed access to premises with
running boiler inside.
Safety rules for user operation:
- Operate the boiler on recommended fuel
only, and to that end you must regularly
inspect the boiler room.
- Do not use flammable liquids for ignition
or increase of burner output.
- Clean the boiler surface using non-
flammable agents only.
- Do not place flammable objects onto the
burner housing and heating boiler cabinet
or in their proximity. (see diagram 1 for
the minimum clearances)
- Do not store flammable materials in the
boiler room.
- It is mandatory to strictly observe
instructions for connecting the burner
to power network as well as to all
peripherals.
- Structural changes of the boiler by user
can cause damage to equipment or injury.
- Do not allow contact transmission of
electrical wire or touch any part of the
boiler, where the surface temperature can
exceed 70 °C.
- This manual should be kept throughout

CAUTION! Hot surface!
Risk of burns if you touch the
running system. Burner housing,
body and flange are hot surfaces
during burner operation.
It is strictly prohibited to open
boiler inspection doors with the
burner running.
The hopper hatch cover is not
allowed to remain open for
longer periods of time.
Also, exercise caution when
touching the observation port for
monitoring the burning process.
It may be hot.

It is mandatory to assure a
backup power generator of
corresponding rated power! (see
table 1)