Burley LONGITUDE, Инструкция по установке, обслуживанию и эксплуатации

Страница: 9 / 20

Page 9 of 20
9 Lighting the Appliance
Ensure that the battery ON/OFF switch located on the receiver holder is in the ON
position (I) & that the MAN/ON selection knob is also pointing upwards towards its ON
position (see below).
Simultaneously press and hold the (red circle) and (large flame) buttons until an
acoustic signal confirms the start sequence has begun, then release the buttons.
Press
these two
buttons
together to
light the
burner
Once lit
use this
button to
increase
gas rate
Once lit
use this
button to
decrease
gas rate
9.1 The acoustic signal should cease and be replaced with the ticking sound of the spark
igniter. When the pilot flame is lit the igniter will stop & another acoustic signal will
confirm the pilot has been established (if the pilot fails to establish repeat the process.
Due to the safe & efficient nature of the fire it is not unusual for this to take two or even
three attempts). The acoustic signal will now cease & the gas rate adjusting knob will
automatically turn to its high setting.
9.2 To adjust the gas rate to desired setting press the (large flame) to increase the flame
height or (small flame) to decrease the flame height on the handset.
9.3 To leave the fire in standby mode press the (small flame) until the main burner goes out.
The pilot should remain on in this mode & help to reduce condensation.
9.4 To turn the fire off completely (including the pilot) press the red OFF button on the
handset.
Gas rate adjusting knob
Remote ON
selector
Remote Control Gas Valve