Burley LONGITUDE, Инструкция по установке, обслуживанию и эксплуатации

Страница: 10 / 20

Page 10 of 20
9.5 Battery Replacement
Handset
On the back of the handset remove the battery cover by pressing down the top of the
cover & sliding it down. Remove & unclip the old battery & replace with a new PP3 9 volt
battery.
Receiver Unit (located on your right hand side behind the trim)
Switch the battery isolator switch to the (O) position. Lift the unit from its carrier carefully
noting the pathway of the associated wiring. Remove the top cover, remove old batteries
& replace with four new AA batteries ensuring the polarities are correct. Replace the
battery cover & return the receiver unit to its original position. Switch the battery isolator
switch back to the (I) position.
Press here and
slide down
CAUTION: With the exception of battery replacement the receiver must be
located in the carrier at all times .
9.6 Pairing Handset to Receiver
If for some reason the remote handset requires re-programming to operate the receiver
follow the procedure below:
1. Press and hold, using a pointed object, the receiver’s reset button until you hear two
acoustic signals.
2. After the second longer acoustic signal, release the reset button and within the
subsequent 20 seconds, press the (small flame) on the remote handset until you hear
an additional long acoustic signal confirming the new code is set.
RESET
DUE TO THE SENSITIVE NATURE OF THE PILOT, IT IS NOT UNUSUAL FOR THE PILOT TO
EXTINGUISH UP TO/AFTER 1 MINUTE WHEN FIRST LIT. RE-LIGHT AND THE PILOT WILL STAY
ALIGHT.