Burkert B0A1C2B1A4A0, Руководство по эксплуатации, Страница: 68 / 92


67
English
SE58
L
Saving the sensor reference data. “meter data” page 80
Sensor ReFerence Data Save
[MCP ONLY] AL4 [SRFDS]
MENU 11 - Function: ONLY MCP FUNCTIONS
MENU 12 - DIAGNOSTIC
Meter auto-test function. This function stops the normal functions of the meter and performs a complete test
cycle on the measure input circuits and on the excitation generator. To activate this function, after select it, push
key Enter, at the question: “CONFIRM EXEC.?” Long Push the same key to start auto-test, or any other key for
cancel the operation. At the end of operation the transmitter will revert to one of the initial visualization pages.
This function is automatically performed when switching on the device. This function restarts the transmitter.
This function performs a manual sensor verification ( if BIV is active)
Flow rate simulation enabling. With this function it is possible to generate an internal signal that simulates the
flow rate, allowing the outputs and all the connected devices test.
After enabling it, a ‘
’ appears in the top left of the screen and the flow rate simulation can be:
• set: by pushing the key Enter from one of visualization pages, to set the required % flow rate (Fl.rate=%)
and the same key to confirm the value;
• finished: by pushing the key Enter from visualization pages and then by long pushing the same key.
(POS. 12.1) AutoTeSt Immediate Command [Self Test] AL3 [ATSIC]
(POS. 12.3) Sensor VERify Command
[ Sens. verify
]
AL3 [SVERC]
(POS. 12.4) Measure SIMulation ENable
[Flow sim=ON]
AL3
[MSIEN]
This Function shows the values of the various internal parameters as listed below :
(POS. 12.5) Diagnostic Measure VaLueS
[Display measures] AL5 [DMVLS]
This function allows to do a physical test of the graphical display. During this operation, 4 sequences are
displayed to test the correct functioning of the device.
(POS. 12.2) Test display
[ Test display ] AL1 NO MCP COMMAND