Bull NovaScale R460 E1, Руководство пользователя, Страница: 52 / 370

User Guide
51
www.bull.com
Turning On the Server
Turn on the server and follow the on-screen instructions for setup.
Caution
Before turning on the server:
■
Some optional boards require setups with the SETUP utility
before installation. If the server has a PCI board with the
PCI-to-PCI bridge installed, the SETUP utility is enabled to
launch. Check on the board specifications to find out
whether it requires pre-installation setups before actually
installing the board.
■
Some installed optional devices or connected peripheral
devices require setups before proceeding to the next step.
To use the server with no optional devices installed besides the
graphic board, install a desired OS to the server.
1. Make sure all external devices, such as a video display, keyboard, and mouse
(optional) have been connected, and the power cords are connected.
2. Power on the video display and any other external devices.
Note: If the server power cord(s) is connected to a power
control unit such as an UPS (Uninterruptible Power Supply),
make sure that the power control unit is powered on.
3. Make sure that any connected USB floppy disk drive contains no floppy disk
and the optical drive contains no bootable CD-ROM or DVD-ROM.
4. Open the front bezel.
5. Press the POWER switch (A in figure below) .
Notes:
■
If the power cord is connected to the power control unit such
as the UPS, turn on the power control unit.
■
If a remote management card (RMC) is installed in your
server, connect the power cord and wait a few seconds
before pressing the POWER switch. The POWER switch
does not work in a few seconds after connecting the power
cord due to RMC firmware start-up.