Bull NovaScale R460 E1, Руководство пользователя, Страница: 327 / 370

User Guide
326
www.bull.com
Windows Server 2003 Clean Installation
This section explains how to perform a clean installation of Windows Server 2003.
1. Turn the system on.
2. Insert the Windows Server 2003 CD-ROM in the optical device drive.
3. Press Ctrl + Alt + Delete to reset the system.
After a bootable operating system has been installed on the hard disk, press
Enter while the message "Press any key to boot from CD..." is displayed at the
top of the screen.
If no bootable operating system exists on the hard disk, this step is unnecessary.
The Windows Server 2003 setup screen will be displayed. If the screen is not
displayed,
Enter was not pressed properly.
Retry after turning the system off and then on again.
4. Press F6 in the few seconds when the window is in one of the following states:
– "Setup is inspecting your computer's hardware configuration..." is displayed.
– A screen with a solid blue background is displayed.
Note: There is no visible indication on screen when F6 has
been pressed.
5. When the following message is displayed, press S .
The following message is then displayed.
6. Insert the Windows Server 2003 OEM-Disk for ExpressBuilder into the floppy
drive, and press Enter .
A list of mass storage devices is displayed.
7. Select the [Intel(R) ESB2 SATA AHCI Controller (Server ESB2)] and press
Enter
.
8. Select the proper SCSI Adapter and press Enter .
- [LSI MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
- [LSI MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
- [LSI Embedded MegaRAID (Windows XP/2003)]
Setup could not determine the type of one or more mass storage devices
installed in your system, or you have chosen to manually specify an adapter.
Currently, Setup will load support for the following mass storage devices.
Please inert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
*Press ENTER when ready.