Bull Cedoc Novascale R422, Инструкция по установке и эксплуатации

Страница: 45 / 134

Advanced Serverboard Setup
5-15
Data Bus Transfer Rate: 8.5 GB/s
Package: FC-LGA6/FC-LGA4, 771 Lands
Special Features
Recovery from AC Power Loss
The feature allows the user to set the power state after a power outage. You can select
Power-Off for the system power to remain off after a power loss. Select Power-On for the
system power to be turned on after a power loss. Select Last State to allow the system to
resume its last state before the power loss. The default setting is Last State.
5-10 PC Health Monitoring
NOTE:
For more information on monitoring the performance and health of your server
see the Bull NovaScale R42x AOC-SIMSO/SIMSO+ Installation and User's
Guide and the Bull NovaScale Master User's Guide
This section describes the PC health monitoring features of the X7DBT/X7DBT-INF.
All models have an onboard System Hardware Monitor chip that supports PC health
monitoring.
An onboard voltage monitor will scan voltages, listed below, continuously. Once a voltage
becomes unstable, a warning is given or an error message is sent to the screen. Users can
adjust the voltage thresholds to de fi ne the sensitivity of the voltage monitor.
Monitored Voltages
Onboard Voltage Monitors for CPU Cores, Memory Voltage, Chipset Voltage
(+1.5V),+1.8V, +3.3V, +5V, +12V, -12V, +3.3V Standby, +5V standby, HT and VBAT
Fan Status Monitor with Firmware Control
The PC health monitor can check the RPM status of the cooling fans. The onboard CPU and
chassis fans are controlled by Thermal Management 2 (TM2) via BIOS (under Hardware
Monitoring in the Advanced Setting).
Environmental Temperature Control
The thermal control sensor monitors the CPU temperature in real time and will turn on
the thermal control fan whenever the CPU temperature exceeds a user-de fi ned threshold.
The overheat circuitry runs independently from the CPU. Once it detects that the CPU
temperature is too high, it will automatically turn on the thermal fan control to prevent any
overheating damage to the CPU. The onboard chassis thermal circuitry can monitor the
overall system temperature and alert users when the chassis temperature is too high.
CPU Fan Auto-Off in Sleep Mode
The CPU fan is activated when the power is turned on. It continues to operate when the
system enters Standby mode. When in sleep mode, the CPU will not run at full power,
thereby generating less heat.
CPU Overheat LED and Control
•
•