Bull Cedoc Novascale R422, Инструкция по установке и эксплуатации

Страница: 36 / 134

5-6
NovaScale R422 Installation and User's Guide
Use your thumb and your index fi nger
to hold the CPU at opposite sides.
Align pin1 of the CPU (the corner
marked with a triangle) with the
notched corner of the CPU socket.
Find the corner of the CPU that has
a semi-circle cutout below a gold
dot (CPU key). This corner should be
aligned with the cutout on the socket
(socket key).
Once aligned, carefully lower the CPU
straight down into the socket. Do not
drop the CPU on the socket, do not
move the CPU horizontally or vertically
and do not rub the CPU against
any surface or any of the contacts,
which may damage the CPU and/or
contacts.
With the CPU in the socket, inspect the
four corners of the CPU to make sure
that it is properly installed.
Use your thumb to gently push the
load lever down until it snaps into the
retention clasp.
If the CPU is properly installed into
the socket, the PnP cap will be
automatically released from the load
plate when the lever locks. Remove the
cap. Repeat steps to install a second
CPU if desired.
!
WARNING! Keep the plastic PnP cap.
The serverboard must be shipped with
the PnP cap properly installed to
protect the CPU socket. Shipment
without the PnP cap properly installed
will void the warranty.
3.
4.
5.
6.
7.
8.
9.
Socket key
CPU key
CPU pin 1
Notched corner
Gold dot
CPU installed in socket
Load lever
PnP cap released
from load plate