Bulex Thema Condens AS 48-A, Руководство пользователя, Страница: 144 / 199

MAKSİCONDENSE 48-65
Notes
01/2018 138 Training 0020260859_00
6.3 Start-up checklist
Activity Description
Rinse the heating installation
DIN EN 14336 prescribes that heating installa-
tions be rinsed or cleaned.
Fill the unit siphon
Before being put into operation, the unit siphon
must be filled with water.
If required, adjust the MAG pre-charge pressure
to the heating installation
The static height of the building must be taken
into consideration here. The calculation for this
is in the formulas in section 8.
Automatic purging mode; select P0 if the instal-
lation is to be purged manually
The pump works in cycling mode
- Purge heating circuit or
- Purge hot water circuit
Fill the unit and the installation to min. 1 bar
Target flow temperature
Setting the maximum target flow temperature
in heating mode to 30 °C–85 °C.
(Setting via the display)
Domestic hot water temperature
Preselecting the maximum DHW temperature
35 °C-65 °C. (Setting via the display)
Partial heat load
Setting the calculated partial heat load within
the unit-dependent range,
D.000 .
Accessory relay 1 (2 in 7 module)
Definition of the aggregate connected to relay
1 of the 2 in 7 module (VR 40),
D.027 .
Accessory relay 2 (2 in 7 module)
Definition of the aggregate connected to relay
2 of the 2 in 7 module (VR 40),
D.028 .
Check the gas connection pressure (flow pres-
sure) and CO2 values in accordance with the
installation instructions
The check programmes " P.01 " (full load) and
" P.02 " (minimum load) are available for this
Check the unit functions (heating mode, domes-
tic hot water mode)
It is best to do this using the Live Monitor ,
since this allows you to read all of the main op-
erating statuses.