Buhler FK370, Руководство оператора и каталог запасных частей

Страница: 17 / 60

16” Backsaver Auger
ASSEMBLY INSTRUCTIONS – cont’d.
ALERT: If the intake auger is removed for repair or replacement, the bolt
coupling the flighting to the intake auger gearbox must be replaced when the
flighting is replaced. Not replacing this bolt could cause failure of the hopper
flighting.
19. Using a 3/8” x 1 ½” key and 3/8” x ¾” sq. hd. set screws, join the hopper flighting
and the intake auger flighting at the universal joint (page 36, #48). Join the
hopper and intake auger using two ¾” x 1 5/8” bolts and lock nuts. A flat washer
goes on the outside only. Parts must swivel freely after bolting together. Check
that the cross on the u-joint is in line with the two pivot bolts.
The cover (page 36, #63) bolts to the front edge of the hopper using ¼” x ¾” hex
bolts, lock washers and hex nuts. The cover is held down by the cover rod
(page 35, #64) which is pushed through the clevises welded to the intake auger
and held in place with a 3/16” x 1 ½” cotter pin. Check that all the set screws on
the u-joint have been tightened and that the u-joint has grease before closing the
cover.
ALERT: Never run the auger without this cover bolted on. The yoke center must
align with the pivot holes after assembly.
20.
Pages 36-39. Bolt the 7” wide rubber edging (#59) supplied to the top edge of
the hopper using ¼” x 1” hex bolts, lock washers and hex nuts. Use 1” wide
strips on the sides of the hopper (#90) and on the outside edge (#88). These
strips fit on the inside of the hopper and help keep the rubber from tearing. The
ends of the rubber strips are joined using connector plates (#91) with ¼” x 1” hex
bolts, flat washers, lock washers and hex nuts.
21.
The lift boom (page 22, #20) is bolted to a welded bracket on top of tube number
1 about 136” from the bottom pipe ring using 5/8” x 1 ¼” hex bolts, lock washers
and hex nuts. The intake auger lift cable (page 22, #85) has a safety hook at one
end. Thread the other end of the 3/8” cable around the pulley at the end of the
lift boom and then around a cable pulley in the bracket which swivels at the back
of the lift boom. Bolt the hydraulic winch (page 22, #89) and solenoid assembly
to the welded winch bracket near the bottom of tube number 1 using ½” x 2” hex
bolts, flat washers, lock washers and hex nuts.
NOTE: The end of the lift cable
must be run through the winch guard (page 22, #93) before attaching the cable to
the winch. Bolt on the winch guard using ½” x 1 ½” hex bolts, lock washers and
hex nuts. There are flat irons with two holes welded near the front on the sides
of the hopper. Hook the lift cable in the upper hole on the far side of the hopper
so the hopper will turn open end toward the auger. This is the standard transport
position. The safety chain is attached to the loop at the top end of the hopper.
This chain should always be attached when transporting the auger. The lift boom
can be used on either side of the auger. The lower hole on the hopper bracket is
used for clean out only.
14