Buhler FK370, Руководство оператора и каталог запасных частей

Страница: 13 / 60

16” Backsaver Auger
ASSEMBLY INSTRUCTIONS
The assembly of this auger will require a 3-ton overhead crane and a forklift. Many of
the components are very heavy so they cannot be maneuvered into place without this
equipment.
1.
Start the assembly by assembling the entire lift system (pages 32-34). With the
axle weldment (#7) turned as shown. Bolt on the stub axles (#58) using ¾” x
2 ¼” hex bolts, lock washers and hex nuts. Mount the wheel and the tire
assemblies (#48) using 5/8” x 2 ½” wheel bolts. Torque wheel bolts to 160 ft/lbs.
ALERT: Do not tighten any hardware for the rest of the lift assembly.
2.
Mount the left hand undercarriage arm (#1) to the welded plate on the axle using
¾” x 2 ½” hex bolts, lock washers and hex nuts. Next attach the left hand lower
lift arm (#9) with a 1 ¼” x 7 1/8” pin (#11) and a ¼” x 1 ¾” cotter pin.
3.
Assemble the two cylinders (#57), the two yokes (#13) and the link weldment
(#14). The yoke arm fits against the outside of the link and against the center
divider of the link. The cylinder ends fit in the open spaces left in the link. Join
parts using a 2” x 18 7/8” pin (#17) and a ¼” x 2 ½” cotter pin.
ALERT: Cylinder ports should be facing down.
4.
Position the cylinder, link arm and yoke assembly up against the left hand lower
lift arm. Before attaching the right hand lower lift arm (#10) to the axle. At this
point you should lift up the ends of the cylinders until the assembly connecting
the lower lift arms is finished. With the cylinders raised, connect the two lower lift
arms with the torque tube weldment (#55) using ½” x 2” hex bolts, lock washers,
flat washers and hex nuts. Welded brackets on the torque tube must be turned
up
5.
Bolt the cradle rest (#12) to the welded brackets on the torque tube using 5/8” x 3
½” hex bolts, lock washers and hex nuts. Connect the yoke, link and cylinder
assembly to the bottom of the lower lift using a 2 ¾” x 39” pin (#20). Fit the end
of the link between the bottom bushings on the lower lift arms. Insert the pin
through the right hand lift arm first, the link second and then the left hand arm.
Lock the ends of the pin in place with ½” x 3 ½” bolts and lock nuts.
6.
Connect the upper lift arm (#8) to the upper bushings on the lower lift arms
using 2” x 9 5/8” pins (#21) and 5/16” x 3” cotter pins. These pins must be
installed with the head of the pin facing the center of the auger and the cotter pin
end facing out. Attach the ends of the yokes to the upper lift arm using a 2” x 20
½” pin (#15) and a ¼” x 2 ½” cotter pin.
10