Buhler FK370, Руководство оператора и каталог запасных частей

Страница: 16 / 60

16” Backsaver Auger
ASSEMBLY INSTRUCTIONS – cont’d.
16.
Lift up the tubing assembly so lift assembly is a few inches above the cradles.
Center the upper lift arm on the cradle. This will require a forklift. Tighten all lift
arm and undercarriage hardware while the tube assembly is raised. Lower back
into cradle when hardware has all been tightened.
17. Using 3/8” x ¾” sq. hd. set screws and a 3/8” x 1 ½” key mount the u-joint
(page 35, #98) on the intake auger gearbox. Position the u-joint by placing a
straight edge along the bottom of the pipe ring on the intake auger top box
(page 35, #67) and measuring exactly 2 ½” from the top of the straight edge to
the center of the u-joint as shown in drawing.
13
18. Pages 35-39. Lift the intake auger assembly onto the input box (#1). The
splines on the U-joint must slide onto the splines on the input box gearbox. This
will require a hoist. Let the ring sit on the input box without forcing it to the exact
center if it is not positioned perfectly. Flip open the intake auger top door (#77)
and bolt on the ring using 3/8” x 1 ½” hex bolts. A 3/8” (10 gauge) flat washer
goes under the input box top cover. The 1 ¼” o.d. flat washers should be 1/8” to
3/16” from touching the edge of the ring. This is done to prevent side pressure
on the u-joint. Four 2” x 6 ½” plates (#33) act as a ring holder. Tighten bolts
using 3/8” lock washers and hex nuts. The intake auger should turn freely
around the input box.