Buell XB9R 2003, Руководство по обслуживанию, Страница: 75 / 566

1-26 2003 Buell XB9R: Maintenance
HOME
IDLER PULLEY REMOVAL
1. See Figure 1-25. Loosen rear axle pinch fastener (2).
2. Unthread axle approximately 15 rotations to release ten-
sion from drive belt.
3. Remove front sprocket cover. See 2.30 SPROCKET
COVER .
4. See Figure 1-26. Remove idler pulley bracket nuts and
washers (5) from studs (3).
5. Slide idler pulley bracket (4) off studs (3).
6. Inspect pulley by spinning wheel (1) and checking for
wheel bearing wear.
7. If pulley wheel needs replacement, remove fastener (6),
washer and nut (2) from idler pulley bracket (4) and dis-
card wheel. Replace with new pulley wheel (1).
NOTE
The pulley wheel bearings can not be replaced separately.
IDLER PULLEY INSTALLATION
1. See Figure 1-26. Install new or existing pulley wheel (1),
if removed, and tighten washer and nut (2) wheel fas-
tener (6) to 96-120 in-lbs (11-14 Nm).
2. Slide idler pulley bracket (4), washer and nuts (5) on to
studs (3) and tighten to 33-35 ft-lbs (45-47 Nm).
3. Install front sprocket cover. See 2.30 SPROCKET
COVER .
CAUTION
Never tighten rear axle with swingarm brace removed.
4. See Figure 1-25. Tighten rear axle to 48-52 ft-lbs (65-
70 Nm).
5. Tighten rear axle pinch fastener (2) to 40-45 ft-lbs (54-
61 Nm).
Figure 1-25. Rear Wheel Mounting, Right Side
8420
2
1. Axle
2. Pinch bolt fastener
1
Figure 1-26. Idler Pulley Assembly
b1106x6x
1
4
2
3
6
1. Wheel
2. Wheel nut
3. Stud
4. Idler pulley bracket
5. Idler pulley bracket nut and washer
6. Wheel fastener
5