Buell XB9R 2003, Руководство по обслуживанию, Страница: 235 / 566

3-44 2003 Buell XB9R: Engine
HOME
CAUTION
Remove shop towel from entrance of throttle body to
ensure proper operation of induction module.
43. See Figure 3-61. Connect throttle position sensor [88].
44. Connect fuel injector leads [84 & 85].
45. Connect fuel line.
46. Install throttle body velocity stack and tighten to 12-36 in-
lbs (1.356-4.064 Nm).
47. Install air box cover and assembly. Tighten fasteners to
84-120 in-lbs (9.49-13.56 Nm).
48. Fill oil tank.
49. Connect fuel pump.
50. Install rear belt and idler pulley. See 1.9 DRIVE BELT
SYSTEM and 2.13 REAR BRAKE MASTER CYLINDER.
51. Install left and right side rider footrests and support
plates and torque to 108-132 in-lbs (12.20-14.91 mm).
NOTE
When re-installing the right side rider footrest and support
plate, also install rear brake pedal assembly and remote res-
ervoir.
52. Install sprocket cover and tighten fasteners and washers
to 12-36 in-lbs (1-4 Nm).
53. Install chin fairing. See 2.33 CHIN FAIRING.
54. Install air scoops, right and left sides. See 2.35 AIR
SCOOPS.
NOTE
The connection for fuel pump is just above the pump located
at the rear of the fuel tank on the left side of the vehicle.
1 1
WARNING
1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
55. Connect negative ground cable to battery and install seat
(tighten).
1 1
WARNING
1
WARNING
Pull up on seat to verify that it is properly secured, front
and rear. A loose seat may shift during vehicle operation
and startle the rider, possibly causing loss of vehicle
control resulting in death or serious injury.
Figure 3-61. Fuel Line and DDFI Electrical Connections
2
1
3
8707
1. Fuel line connection
2. Connection for throttle position sensor [88]
3. Connections for fuel injectors [84 & 85]