Buell XB9R 2003, Руководство по обслуживанию, Страница: 186 / 566

2003 Buell XB9R: Chassis 2-81
HOME
SEAT 2.38
REMOVAL
Rider Seat
1. See Figure 2-114. Peel up rear corners of seat and
remove two fasteners.
2. Pull seat back over tail section and remove.
Pillion Seat
NOTE
The trunk is located under the pillion seat.
1. See Figure 2-115. Insert ignition key into pillion seat lock
located on left side of motorcycle. Turn key clockwise to
disengage rear seat latch.
CAUTION
Do not place keys in underseat storage area. If seat is
installed, keys will not be accessible.
2. Lift and remove pillion seat.
INSTALLATION
Rider Seat
1. Position seat in mounting position with center tab aligned
with slot on frame crossmember.
2. Slide seat forward to engage center tab in slot. Pull up on
front of seat to verify tab/slot engagement.
1 1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
3. Pull up rear corners of seat and tighten two fasteners to
12-36 in-lbs (1-4 Nm).
Pillion Seat
1. Install seat by sliding metal locating tab on front under-
side of seat into opening on motorcycle.
2. Align rear tab with latch slot at rear of motorcycle.
3. Press down firmly on rear of pillion seat to engage seat
latch. Pull up on rear of pillion seat to make sure latch is
engaged.
4. Turn ignition key counterclockwise and remove from seat
lock.
Figure 2-114. Accessing Rider Seat Screws
Figure 2-115. Pillion Seat Lock
Figure 2-116. Center Tab and Frame Slot
8343
8344
8365