Bruno SRE-2700, Руководство по установке

Страница: 32 / 57

©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2700 06-11-2004
32
ELECTRICAL
ELECTRICAL
To convert the rocker switch to the left armrest:
1) Remove the (4) Phillips flat head machine
screws securing the seat cushion.
2) Pull out the black, split grommet (a) located
under the rocker switch.
3) Carefully remove the rocker switch (b) from
its housing (c):
• Gently pry under the switch gasket, all
the way around the switch.
• Once the switch is free from the housing,
carefully pull it out of the housing.
4) Disconnect the rocker switch wire harness.
NOTE WIRE COLOR LOCATIONS AND SWITCH ORIENTATION
(a)
(b)
(c)
5) Unscrew the screw (d) securing the rocker switch housing to the armrest tube.
6) Remove the black grommet from the back of the rocker switch housing.
7) Place the wire harness connectors one behind the other (in line). Use masking tape to
hold in this position.
8) Pull the taped end of the wire harness through the back of the housing.
9) Remove the black, split grommet (e) from the hole in the center of the armrest weldment.
10) From the hole in the center of the armrest weldment, pull the wire harness out of the right
armrest weldment.
11) Pop out the black dome cap plug (f) from the LEFT armrest tube. Insert it in the hole in the
RIGHT armrest tube (hole created by the removal of the bushing in Step No. 2).
12) Carefully thread the taped end of the wire harness into the center hole and up the left
armrest tube.
11) When the taped end becomes visible through the hole in the armrest tube (hole created by
removal of the cap plug in Step No. 11), carefully extract the harness using needle-nose pliers.
12) Mount the rocker switch housing (c) on the left armrest tube using screw (d) removed in
Step No. 5.
13) Gently feed the rocker switch wire harness through the back on the rocker switch housing
until it comes out the front of the housing.
14) Untape the wire harness connectors and connect to the rocker switch.
15) Carefully push the rocker switch into the housing until it "snaps" securely into place.
16) Reinsert the black, split grommets: 2 in the rocker switch housing and 1 in the center of the
armrest weldment.
17) Before securing seat cushion, make sure the wire harness will lie in the channel (g) in the
bottom of the seat.
18) Secure the seat cushion using the (4) Phillips flat head machine screws removed in Step No. 1.
(d)
(e)
(f)
(g)