Bruno SRE-2700, Руководство по установке

Страница: 29 / 57

©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
29
SRE-2700 06-11-2004
INSTALLATION
INSTALLATION
TT
• Verify proper operation of the power supply, call/send transmitters, on/off switch, footrest,
safety switches, and carriage limit switches.
• Inform the customer of the location of the Owner's Manual. Encourage him/her to become
familiar with its contents.
• Train the customer to use the stairway elevator correctly and safely. Be sure to have him/her
operate the unit while you are there to answer any questions and address any concerns.
WHEN THE INSTALLATION IS COMPLETE
•
10) Make sure both transmitters are set to the same switch
configuration.
11) Remount and secure the transmitter back (remount on
wall if applicable).
12) Remount the carriage cover.
13) Remount the footrest.
14) Reinsert the black plug into the hole in the carriage
cover.
NOTE:
While using the remote
call/send, you may experi-
ence some
intermittent operation.
This will not harm the
unit. However, while
using the rocker switch,
operation should NOT be
intermittent.
9) Once you have changed the switch positions:
• Turn on the CARRIAGE circuit breaker.
• Wait until you hear a BEEP.
• Using a flat-nose screwdriver, reach through the hole
in the CARRIAGE COVER to press and hold the
red button on the CARRIAGE circuit board.
• AS YOU HOLD DOWN the red button, press one of
the pushbuttons on the TRANSMITTER.
• Count to five.
• Release the two buttons.
• Depress either of the transmitter buttons.
• If the carriage moves, the new configuration has been
accepted and the transmitter relearned.
• If the carriage does not move, repeats Steps 8 and 9.
close-up of red button
as seen through plug hole