Bruno SRE-2700, Руководство по установке

Страница: 28 / 57

©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2700 06-11-2004
28
INSTALLATION
LEARNING THE REMOTE INFRARED TRANSMITTER
(not necessary when installing unit for the first time) R
INSTALLATION
The operating channel of the two (2) infrared transmitters
included with the SRE-2700 is pre-set at the Bruno factory.
Should it become necessary to re-learn the transmitters
(for example, if there are multiple units in the same location,
or in the event you have to replace tranmitters) proceed as follows:
1) Turn off the circuit breaker.
2) On the CARRIAGE COVER, locate and remove the 3/4" black plug
(center top of the carriage approximately half-way between the
two white infrared receivers). Please refer to the photo to the left.
3) Look through the hole in the carriage cover and locate the RED
BUTTON on the circuit board.
4) Have a flat-nose screwdriver nearby. You will use it to press the
red button (through the carriage cover hole) in a later step.
5) On one of the IR TRANSMITTERS, remove the screw (a) securing
the back to the transmitter. [If the transmitter is mounted to a
wall, unscrew the (2) mounting bracket screws, turn the
transmitter over and remove screw (a) securing the mounting
bracket and the transmitter back.]
6) Remove the transmitter back and set aside with its screw.
7) On the TRANSMITTER board, locate the blue switch (b)
labelled "SW".
8) Change the configuration for switches 1 and 2.
Note: There are four possible configurations:
•1 up, 2 down (default manufacturer's setting)
•1 up, 2 up
•1 down, 2 up
•1 down, 2 down
(a)
(b)
(c)
(c)
plug removed