Bruno SRE-2700, Руководство по установке

Страница: 31 / 57

©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
31
SRE-2700 06-11-2004
ELECTRICAL
REVERSING OPERATION (for right-hand installation)
As shipped from the factory, the Elevator is set up for left-hand installation (as viewed from the
bottom of the stairs.)
In the field, however, should the dealer/installer need to convert the Elevator from left-hand to right-
hand operation, follow the instructions given below.
Note that it is not necessary to change the rocker switch when converting to a right-hand
installation. Only in the event that the user does not have use of his/her right hand would moving
the rocker switch to the left armrest be necessary.
Instructions for changing the rocker switch from the right armrest to the left armrest immediately
follow the instructions for converting the circuit board for right-hand operation.
To convert the rail/carriage for right-hand operation:
(a)
(a)
(b)
(b)
(a & b)
(a & b)
(c)
carriage: top view
carriage and
footrest: front view
access hole (a) to circuit board
with plug (b) removed
jumper (c) on circuit board as
seen through hole (a)
(c)
jumper
1) Remove the 3/4" black plug (b) located in the
center top of the carriage (approx. half-way
between the two white infrared receivers).
2) Look through the hole now exposed in the
carriage. Visually locate the jumper (c)
on the circuit board.
3) Carefully grasp the jumper (c) with a pair of
needle-nose pliers.
4) Pull up on the jumper (c) with the pliers to
disengage the jumper from the pins on the
circuit board.
5) Remove the jumper (c) from the carriage.
6) Insert the plug (b) into the hole (a) in the top
of the carriage.
7) Place the jumper in the bag with the
technical manual and give to the owner of the
SRE-2700 for future use should s/he wish to
convert the unit back to left-hand operation.
8) Removal of the jumper automatically converts
the circuit board of the SRE-2700 to right-hand
operation.
Three pins are now exposed on the circuit board.