Bruno SRE-2700, Руководство по установке

Страница: 10 / 57

©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-2700 06-11-2004
10
INSTALLATION
1) Determine whether a left- or right-side installation is appropriate for the site. "Left" or
"right" refers to the side of the stairway on which the rail is installed (as viewed from the
bottom of the stairs). Unless otherwise specified Bruno Stairway Elevators are shipped
from the factory in the left-side configuration. Conversion to right-side installation is
easy (instructions included later in this manual ).
2) Identify and locate lower rail section appropriate to the installation (left or right).
BUMPER BRACKET INSTALLATION
1) Assemble lower rail.
2) Install lower bumper bracket.
FITTING THE RAIL
1) Determine the correct length for the rail by measuring along a straight line placed on the
stairs. (SEE STEP 2 IN THE APPLICATION GUIDE) To that amount, add Measurement B
(STEP 4 IN THE APPLICATION GUIDE). This process will allow you to custom fit the
Elevator to your customer by determining the most comfortable seat-to-floor height within
the space available at the top of the stairs.
NOTE: The rail must rest approximately 2" above the step nosing, and extend from the lower floor to a
point beyond the nosing of the top step (see Step No. 4 of the Application Guide). In some cases where
the bottom landing is made of material such as concrete, ceramic tile or slate, the last bracket on the
landing may be omitted. In this case, a bracket must be added on the second-to-last step ( bottom), and
at the top of the stairway.
REMINDER:
THIS RAIL MUST BE INSTALLED APPROXIMATELY 2" ABOVE STAIR NOSING.
OTHERWISE, FOOTREST WILL HIT THE STEPS, CAUSING INTERMITTENT
OPERATION.
bumper bracket
INSTALLATION
ASSEMBLY