Bruno SRE-2700, Руководство по установке

Страница: 27 / 57

©2004,2002 BRUNO INDEPENDENT LIVING AIDS, INC.®
27
SRE-2700 06-11-2004
1) On the back of the transmitter, loosen and remove the
screw (a) securing the two halves of the transmitter.
2) Place the bracket (b) on the back of the transmitter.
The base of the bracket will be flush with the
bottom of the transmitter, with the base of the
bracket pointing toward the front of the transmitter.
3) Insert the longest screw provided in the mounting
hardware kit (see illustration above left) through the top
hole in the bracket and through the corresponding
hole in the back of the transmitter. Tighten, without
overtightening to avoid damaging the transmitter back.
4) Turn the transmitter/bracket unit over so that the
front of the transmitter is facing you.
5) Mount this unit to the wall using the two (2)
#8 x .75" lg Phillips pan head sheet metal screws and
the two (2) plastic ribbed anchors provided.
6) Run the unit up and down the stairs using the remote
call/sent transmitter. Test both transmitters.
7) Repeat the test with the installer or installer's
assistant sitting on the seat.
MOUNTING THE CALL/SEND TRANSMITTERS
TO THE WALL
STANDARD
CALL/SEND TRANSMITTER
NOTE:
INSTALLATION OF THE
CALL/SEND UNIT MAY VARY
BY LOCAL CODE. PLEASE
REFER TO LOCAL CODES
FOR
INSTALLATION
GUIDELINES.
INSTALLATION
(a)
(b)
Step 1
Steps
2 & 3
Step 4
Step 5
Remember to mount the transmitters
in locations which are out of the reach
of children, yet always visible to the
operator from the stairway elevator.
bracket and mounting hardware
INSTALLATION
The 9V battery is inserted backwards in the IR transmitter
when shipped from the Bruno factory. Prior to operating
the SRE-2700, the installer must remove the battery and
reinsert it so that the (+) and (-) poles are properly connected.