Brother 884-T13, Руководство по эксплуатации

Страница: 230 / 316

228
■
When using Tajima embroidery data
(.dst)
b
If “ON” is selected, touch and to
select the number of feed codes.
The desired setting is displayed.
• A value between 1 and 8 can be specified. For
example, if 3 is specified, sequential 3 jump codes
will be converted to the trim code. But sequential 2
jump codes will not be converted to the trim code, it
will be sewed as the feed (jump) stitch.
Deleting short stitches
If embroidery data other than our original patterns
are used, the stitch length may be too short,
possibly resulting in the thread or the needle
breaking. In order to prevent this problem from
occurring, the machine can be set to delete
stitches with a short stitch length. Stitches with a
length less than that specified in this function, can
be deleted.
When the embroidery machine is purchased,
“0.3” was selected (delete stitches with a length of
0.3 mm or less).
a
Touch and to select the stitch length.
The desired size is displayed.
• A value between 0 and 1 millimeters if the units of
measurements is set to “mm” (or a value between 0
and 0.04 inch if the units of measurements is set to
“inch”) can be specified.
Specifying the remaining length
of thread
This setting specifies whether the length of upper
thread that remains threaded through the needle
after the thread is trimmed (length of thread passed
through the eye of the needle) has a standard tail
or long tail.
When the embroidery machine is purchased,
“Standard Tail” is selected.
The setting for the remaining length of thread can
be specified from page 2 of the settings screen.
a
Touch and to select the setting.
The desired length is displayed.
• If the machine misses stitches with a standard length
of thread after it is trimmed, select “Long Tail”.
• When using metallic thread, select “Long Tail”.
Note
• You need to set the jump number same as
the number that was used when the
particular Tajima data was created.
If the jump number is not matched, either
unexpected trim or no trimming at trim
expected point will happen.
Note
• If the setting is changed from the previous
setting, the new setting is only applied to
the next embroidery.