EMBROIDERING TUTORIAL
37
2
b
Pass the thread through the thread slit and
under the tension-adjusting spring.
1
Thread slit
2
Tension-adjusting spring
c
Pull the thread about 50 mm (2 inches)
through the opening in the tension-
adjusting spring.
1
About 50 mm (2 inches).
For adjusting the tension of the bobbin thread, refer
to “Adjusting the tension of the bobbin thread” on
page 124.
Installing the bobbin case
a
Insert the bobbin case into the hook.
Insert the bobbin case while aligning the tab on the
bobbin case with the notch in the hook, as shown in
the illustration.
1
Tab
2
Notch
b
Fully insert the bobbin case until it snaps
into place.
c
Close the hook cover.
Note
• Check that the thread winds off the bobbin
clockwise as shown in the illustration. If the
bobbin is installed with the thread winding
off in the opposite direction, the embroidery
will not be sewn correctly.
Содержание 884-T13
Страница 54: ...52 Continuing to the embroidering settings screen a Press The embroidering settings screen is displayed ...
Страница 148: ...146 ...
Страница 245: ...APPENDIX 243 7 f Attach the embroidery frame removed in step d and then finish embroidering the appliqué ...
Страница 308: ...306 If any of the following messages appear consult your nearest authorized Brother dealer ...