18
Bradmar
™
Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Installation
10/1/2014
Bradley
•
HDWP-INSTR-013 Rev. K; ECN 12-14-012
9c Latch and Keeper for No-Site Outswing Doors
D
C
Line up the top of the keeper with he mark on the pilaster .
Using the keeper as a template, drill Ø
⁷⁄₃₂
" x ¾"(19mm)
deep holes into the pilaster . It is not necessary to remove
the keeper before drilling. Secure the keeper to the
pilaster using hardware provided .
E
Measure 5½" from the latched side of the door and 29¼" up
from the bottom of the door. Drill a Ø ¼" hole through the
face of the door. Drill an identical hole, 3½" below the hole
just drilled . Install one door pull to each side of the door with
the hardware provided .
Using the latch mounting holes as a template, drill a Ø
⁷⁄₃₂
"
pilot hole into the door, ¾" (19mm) deep. Secure the latch
to the door using hardware provided .
A
B
G
F
H
With the door in the closed position, mount the latch on the
inside of the door so that the center of the slide bar is 27½"
(699mm) from the top of the door. The leading edge of the
latch should be positioned approximately
¹⁄₈
" (3mm) from the
"inside face" door edge .
Install the coat hook according to local codes . See
step 9a letter G on page 16 for suggested location .
For wall bumper install see step 9a letter F on page 17.
Repeat steps A-G for remaining doors .
The measurement from the top of the door to the top of the
keeper is 27
⁹⁄₁₆
" (700mm). Mark this on the inside of the
pilaster, opposite the hinged side of the door . The leading
edge of the keeper should be lined up with the edge of the
pilaster notch (approximately
⁵⁄₈
" [16mm] in from the edge of
the pilaster).
#14 x ¾" Screw
#14 x ¾" Screw
#10-24 x 2"
Machine
Screw
Door Pull
Pilaster (Double Strike
Shown)
Door
Keeper
Lip
5½"
27½"
¹⁄₈
"
27
⁹⁄₁₆
"
⁵⁄₈
"
Door Pull w/ Countersink
(added for 32"-36"
inswing ADA Doors)
Slide Latch
Local codes vary from state to state. Check your local
codes before installing the coat hook and door pulls.
