Bradley Bradmar 400 Series, Руководство по установке

Страница: 17 / 21

17
Installation
Bradmar
™
Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley
•
HDWP-INSTR-013 Rev. K; ECN 12-14-012 10/1/2014
9b Latch and Keeper for No-Site Inswing Doors
Local codes vary from state to state. Check your local
codes before installing the coat hook and door pulls.
C
Line up the top of the keeper with the mark on the pilaster .
Using the keeper as a template, drill Ø
⁷⁄₃₂
" x ¾"(19mm)
deep holes into the pilaster . It is not necessary to remove
the keeper before drilling. Secure the keeper to the pilaster
using hardware provided .
E
For 32"-26" ADA doors, measure 5½" from the latched side
of the door and 25¾" down from the top of the door . Drill
a Ø ¼" hole through the face of the door . Drill an identical
hole, 3½" below the hole just drilled. Install one door pull to
each side of the door with the hardware provided .
D
Using the latch mounting holes as a template, drill a Ø
⁷⁄₃₂
"
pilot hole into the door, ¾" (19mm)deep. Secure the latch to
the door using hardware provided .
B
With the door in the closed position, mount the latch on
the inside of the door so that the center of the slide bar
is 27½" (699mm) from the top of the door. The leading
edge of the latch should be positioned approximately
³⁄₈
" (10mm) from the door edge "lip." If stainless steel
hardware is used, this distance should be 1
¹⁄₈
" (29mm).
F
For coat hook install see Step 9 letter F on page 15 .
G
Repeat steps A-F for remaining doors .
A
The measurement from the top of the door to the top of the
keeper is 27
⁹⁄₁₆
" (700mm). Mark this on the inside of the
pilaster, opposite the hinged side of the door . The leading
edge of the keeper should be lined up with the edge of the
pilaster notch (approximately
⁵⁄₈
" [16mm] in from the edge
of the pilaster).
#14 x ¾" Screw
#14 x ¾" Screw
#10-24 x 2"
Machine Screw
Door
Pull
Pilaster (Double
Strike Shown)
Door
Keeper
Lip
5½"
27½"
**
³⁄₈
"
27
⁹⁄₁₆
"
⁵⁄₈
"
Door Pull w/
Countersink (added
for 32"-36" inswing
ADA Doors)
Slide Latch
**If stainless steel hardware is used measurement should be
¹⁄₈
"