80
EN
Mitho
THE ROOMS MENU
Blocking a light point
In the system programming phase it is possible to set a particular blocking configuration for a light point; when the
"Block" function is activated, the light point reaches the programmed configuration and the commands arriving
from other devices, timers, scenarios are ignored until the "Block" is removed .
No “Block” active
“Block” active
Possible options for RGB lights
Buttons
C
, enable the brightness of the light point to
be taken to the maximum (100%) or minimum (0%) .
By selecting any point on area
D
, it is possible to
choose the colour tone desired for the light point .
The cursor
E
, enables the brightness of the light point
to be adjusted .
By pressing button
F
, a different mode of adjusting
the colour and brightness of the light point is displayed .
The colour sample
G
, represents the last shade created
and is suggested again even if another RGB light point
is being configured .
Button
H
, restores the previous display mode .
Square
9
corresponds to the feedback of the colour (if
managed by the device being controlled) .
RGB Living room
RGB Living room
3
3
7
9
9
7
4
5
6
8
