Boumatic StepMetrix, Инструкция по установке, эксплуатации, техническому обслуживанию и ремонту

Страница: 9 / 35

8.
StepMetrix sensor module dimensions and mounting locations l864_8
2.1.5
Installing the StepMetrix Positioning Rails
The StepMetrix positioning rails are used to center the
cows on the StepMetrix sensor module. To inst all
them, perform the following steps:
1. Place the p ositioning rails in the step up and step
down. Bolt the rails in place (see Figure 9).
2. Slide the step up and step down toward the s ensor
module, connecting the positioning rails together with
the plastic antenna supports as shown in Figure 9.
3. Position the step up and step down so there is a 1-inch
(25 mm) gap bet ween each step and t he sensor
module.
4. Walk on the step up an d step down to check for
rocking. If the step up or step do wn rocks place shims
underneath to prevent rocking.
5. Fasten the step up and the step down to the floor using
concrete anchors (see Figure 9).
6. Mount the antenna to the p ositioning rails using the
antenna rail bracket, as shown in Figure 10.
7. Attach the antenna shield to the positioning rails using
the antenna shield-mounting bracket, as sho wn in
Figure 10.
2.1.6
Installing the StepMetrix Controller
— NOTE ———————————————————
⎯⎯⎯
Route wiring through conduit for protectio n and aesthetic
purposes.
1. Select a location to mount the StepMetrix controller
where the ce nter of the bot tom of the b ox is no mor e
than 58” (1473 mm) from the t op of the Ste pMetrix ID
antenna where the flex conduit emerges. The controller
should be out of reach of cow traffic but accessible for
service.
2. Using suitable fasteners, mount the controller securely
to a stur dy structure or wall in a way that minimizes
vibration to the controller.
3. Connect the flex conduits from the Ste pMetrix ID
antenna and the se nsor module to the bottom of the
controller (see F igure 11).
StepMetrix™ Installation Instructions 9E-864C 9