Boumatic StepMetrix, Инструкция по установке, эксплуатации, техническому обслуживанию и ремонту

Страница: 7 / 35

controller must be co nsidered before starting
installation.
• The StepMetrix ID a ntenna must be inst alled at the
center of, a nd perpendicular to, the sens or module.
The top of the ID antenna where the conduit emerges
must be no more than 5 8 inches (1473 mm) from the
center of the bottom of the StepMetrix controller.
1. Secure the ID antenna to the floor usi ng 4 concrete
anchors (see Figure 6).
2.1.2
Installing the StepMetrix Sensor Module
1. Place the StepMetrix sensor module on the floor with
the conduits for the load cell cables on the same side
as the conduit on the ID antenna.
2. Center the sensor module from side to side and end-to-
end in the StepMetrix ID antenna (see Figure 8).
3. Once sensor module is placed on the floor, walk on the
right and left sides of the se nsor module. If the sens or
module rocks, add sh ims underneath to stop the
rocking (see Figure 7). If the sensor module is fastened
to the floor without shimming to eliminate the rocking, it
will cause a twist in the sensor module that will hamper
the performance of the system and may cause
premature failure of the load cells.
4. Once the sensor module is neither rocking nor twisted,
fasten the sen sor module to the floor usin g concrete
anchors.
5. Walk on the sensor module after fastening the anchors
to make sure that the sensor module is not rocking.
2.1.3
Installing the StepMetrix Step-Up
1. Place the Ste pMetrix step-up on the flo or before th e
StepMetrix sensor module. Do not fasten the step-up to
the floor at thi s point. T he positioning rails need to be
assembled first (see Figure 9).
2.1.4
Installing the StepMetrix Step-Down
1. Place the StepMetrix step-down on the floor after the
sensor module.
2. Do not fasten the step-down to the floor at this po int.
The StepMetrix P ositioning rails must be assembled
first (see Figure 9).
5.
The StepMetrix in place l864_5
StepMetrix™ Installation Instructions 9E-864C 7