Boumatic StepMetrix, Инструкция по установке, эксплуатации, техническому обслуживанию и ремонту

Страница: 6 / 35

4.
StepMetrix location, rotary parlor l864_4
1.3
Reviewing Personal Safety Instructions
To prevent possible bodily injury, foll ow the safety
instructions below and throughout this booklet.
— Warning ———————————
⎯⎯⎯
9E-864C StepMetrix™ Installation Instructions 6
Turn off and lockout p ower to the po wer supply before
wiring the power for the St epMetrix. Failure to do s o could
cause serious injury or death.
2.
Installation
The installation of the StepMetrix sy stem is a mult i-
step process. Follow installation steps as described in
the following sections.
— NOTE ———————————————————
⎯⎯
•
Review the instructions on page 1 under the
heading "Responsibilities" and perform only those
steps in this section that you are responsible for
performing.
•
Review the personal safety message s and
installation specifications in Sectio n 1 and
instructions throughout this packet before starting
the procedure(s) in this section.
•
Sides of the sensor module are defined as left
and right, as viewed from the direction of the cow
flow with respect to ¾” (19 mm) load cell conduit.
•
Spacing of StepMetrix co mponents is critical for
best performance. Do not d eviate from
recommended dimensions
•
It may be necessa ry to remove th e existing
railings in the installation area if the exit alleyway
is narrower than the recommended dimensions.
•
The step assembly that is pla ced before the
sensor module will be referred as the StepMetrix
step up, while the ste p assembly that is pla ced
after the sensor module, will be referred as the
StepMetrix step down.
2.1
Installing the StepMetrix with a BouMatic
ID System
2.1.1
Installing the StepMetrix ID Antenna
— NOTE ———————————————————
⎯⎯⎯
• The placement of the St epMetrix ID a ntenna and
StepMetrix controller determine the placement of th e
entire installation.
•
The wire lengths of the load cell cables and ID antenna
cannot be ch anged; therefore the l ocation of th e