Boston Whaler 420 OUTRAGE, Руководство пользователя

Страница: 89 / 268

2-41 420 Outrage
Chapter 2 • General Information
R
!
CAUTION
Ensure that there are no rods in the hardtop rod
holders before activating the sun shade.
!
CAUTION
In rough seas the sunshade should be stowed
to prevent damage to the rails and or curtain.
the proper way to secure the boat and how best to
use the mooring points of your boat.
Figure 2.41.1 shows the correct method for tieing a
belaying knot, commonly used to secure a boat to a
dock. This knot will hold fast and is simple to release
when needed.
The bow eye is used to haul and hold your boat onto
a trailer. The stern eyes are used as tie down points
while trailering the boat. Do not use the bow and
stern eyes for lifting the boat.
The windshield wiper and washer are controlled by
switches on the helm port switch panel. The switches
are protected by 20 amp reset breakers located on
the DC breaker panel on the port side of the cabin.
The washer is
activated by
momentarily
pushing the
switch.
Windshield Wipers/Washer
FWD AFT AUX
BILGE PUMPS
HORN
MODE SHADE VENT
WASHER WIPER
The LED will again remain illuminated for a short
period of time.
The sun shade and shade controller is protected
by breakers located on the port side of the hardtop
electronic box above the helm.
Follow the canvas care instructions in section 5 of
this manual to keep the sun shade fabric clean.
NOTICE
Before removing your boat from the water be
sure to close the A/C seacock. Failure to do so
will cause an air lock in the line when the boat
is returned to the water. The A/C system will
then have to be primed before it will operate
properly.
Lifting
Docking, Lifting and Trailering
Docking
Your boat has nine cleats, one located in the anchor
locker, two located at the bow, two located amidships,
two located in the aft cockpit under the gunwale and
two at the stern.
The cleats are used to secure the boat to the dock.
While loading/unloading or mooring, please learn
From
Boat
From
Boat
From
Boat
(Make loop and rotate before pulling over the horn)
(1)
(2)
(3)
Belaying Knot
Figure 2.41.1
(4)
Horn
of cleat
Pull
tight
(Make loop and
rotate before pull-
ing over the horn)