Boston Whaler 420 OUTRAGE, Руководство пользователя

Страница: 147 / 268

4-1
Chapter 4 • Electrical
420 Outrage
R
Your boat is equipped with an electrical system
powered by a series of batteries. The batteries
are charged by running the generator or when the
engines are running or can be charged by shore power
when the engines and generator are off. A battery
charger located on the forward wall of the battery
compartment facilitates the charging of the batteries
when using shore power. The electrical system
utilizes selector switches to control the delivery
of power to engine ignition, engine trim system,
helm instrumentation, lighting/navigation, livewell
system, and add-on accessories and electronics.
Batteries
DC Electrical System
Application Group Volts MCA* RC 25 Qty.
USA (SAE) 31 12 800 135 min 7
* Marine Cranking Amps
** Additional battery needed with triple engines.
Application Group Volts CCA* Reserve Qty.
Int’l (EN) 31 12 975 65Ah 7
* Cold Cranking Amps
Batteries contain sulfuric acid which can cause
serious injury. Avoid contact with skin, eyes and
clothing. If contact occurs, flush affected area
with water and seek medical attention.
!
DANGER
NOTICE
Ensure batteries meet Mercury’s AGM/CCA
requirements.
Store batteries in battery trays. Use retaining
lid and nylon lock nuts to keep batteries secure.
REFER TO ENGINE MANUFACTURER’S MANUAL IN
OWNER’S PACKET FOR COMPLETE INSTRUCTIONS
AND WARRANTY INFORMATION.
Use only AGM batteries with Mercury Verado
engines. Table below is for reference purposes only.
Battery Trays
Batteries are secured in battery trays and held in place
by retaining brackets (Figure 4.2.1). The trays ensure
that while underway the batteries do not move around,
thus causing damage to components fitted in the same
area. To remove battery(ies), disconnect negative wires
followed by positive wires, and then remove retaining
lid and hold down on battery tray.
Standard Battery Plate
420OR
BATTERY LOCATIONS
2385022
SEE OWNERS MANUAL FOR DETAILED SPECIFICATION.
SET BATTERY CHARGER TO BATTERY MANUFACTURERS RECOMMENDED
SETTINGS.
FORWARD BERTH ACCESS
BATTERIES #7 & #8 ARE IN SERIES, PROVIDING 24VDC POWER TO THE
BOW THRUSTER LOAD.
FWD
+
AGM
5
PORT
STBD
+
AGM
4
+
AGM
3
+
AGM
2
+
AGM
6
+
AGM
7 AGM
8
AGM
1
BILGE - STBD BANK
BATTERY #1 IS FOR STBD ENGINE AND GENERATOR IF EQUIPPED.
BILGE - PORT BANK
BATTERY #2 IS FOR PORT ENGINE
BATTERY #3 IS FOR CENTER ENGINE
BATTERIES #4,#5,#6 ARE IN PARALLEL, PROVIDING 12VDC POWER TO
THE HOUSE LOAD.
V12 Engine Equipped Battery Plate
!
WARNING
Use only deep-cycle, sealed design batteries for
bow thruster. Failure to do so will result in an
increased and dangerous presence of battery
discharge gases accumulating in forward cabin.