AVIDEA SYSTEM SETUP
: The Avidea Control Center
Placement of the Avidea Control Center is a matter of convenience. Things to keep in mind
include the distance from the Avidea Subwoofer (it will be connected to the subwoofer with
a supplied 16 foot (5m) cable; an optional A7lc 66 foot (20m) cable is available), and proximity
to an electrical outlet.
x
Note : Please do not plug the Control Center into an electrical outlet until all other connections are made.
: The Avidea Subwoofer
Place the Avidea Subwoofer close enough to the Control Center to allow the supplied subwoofer
cable to reach it. Also, the subwoofer needs to be close to an electrical outlet. Increased bass
performance can be achieved by moving the subwoofer closer to a corner. Ensure that you allow
an adequate distance between the rear of the subwoofer and the wall and other objects for proper
heat dissipation. The subwoofer is not magnetically shielded and should be kept at least 18 inches
(50cm) away from most televisions to avoid interference with the video image.
x
Note : Please do not plug the subwoofer into an electrical outlet until all other connections are made.
: The Avidea Speakers
The Avidea Speakers can be placed on existing shelving or furniture with the application of the
supplied rubber feet to the bottom of the speaker. The speakers can also be wall mounted using
screws and the keyhole mounts on the speaker’s rear panel. Mounting templates are provided at
the back of this guide to assist you in wall mounting the speakers.
x
Note : Please consult a qualified installer to assure use of the proper fasteners for your wall surface.
The optional UMB1 wall-mount brackets provide tilt and swivel capability, while the optional A7fs
floor stands place the speaker at the proper listening height in rooms where wall mounting or
shelf placement is not convenient.
.
.
.
.
.
.
INST
ALLA
TION
11
S-Video Cable :
6.5 feet (2m)
Used to connect the Avidea Control Center to
the S-Video input/output of a television or
other video component.
Composite Video Cable :
5.25 feet (1.6m)
Used to connect the Avidea Control Center to
the Composite Video input/output of a televi-
sion or other video component.
Audio Cable :
5.25 feet (1.6m)
Used to connect the Avidea Control Center to
the stereo input/output of an audio or video
component.
Center Channel Speaker Posts
Two “threaded posts” are supplied to allow
the center channel speaker to sit properly on
a flat surface or when placed on top of some
televisions with shallow tops. Depending on
the television, you may need to use the short
or long post to provide support for the rear
of the speaker onto the back of the television.
The short post comes pre-installed, and can be
slightly extended to keep the speaker from
rocking backwards when it is placed on a
flat surface.
IR Emitter :
6.5 feet (2m)
Provides IR signal to conventional IR
components when using RF to control them.
Rubber Feet
The self-adhesive feet may be used on the
bottom of the Avidea Speakers to help protect
your furniture. They can also help minimize
the speakers’ movement when the system is
played at high volumes. Place one foot at
each corner at the front bottom edge of the
center channel speaker. Use one foot at each
of the four corners on the bottom of the
other speakers.
. . .
. . .
INTRODUC
TION
10
OPTIONAL ACCESSORIES
The A7fs floor stand and UMB1 wall bracket are available to allow you to place the speakers
around the room in a manner that is convenient and aesthetically pleasing. See your Boston Acoustics
dealer for additional information.
Additional Avidea Remote Controls (A7rc) are available and are particularly useful when establishing
a second Zone outside your main listening area. (See ‘Zone 2 Installation and Operation’ on page 55.)
A 66 foot (20m) CL2-rated Subwoofer cable (A7lc) is available for installations that require long
cable runs between the Avidea Control Center and the Avidea Subwoofer. A CL2 rating is required
when the cable is installed in walls, floors, and ceilings.
INSTALLATION
02
SECTION
01
SECTION
INTRODUCTION
