Tuner Direct
The fourth LCD page allows you to tune directly to an AM or FM station by frequency. First choose
the band you wish to access: AM, FM, or FM Mono. Enter all the digits for that station. For example:
102.5 would be entered as “1”,“0”,“2”,“5”. Then press enter.
Tuner Macros
The fifth LCD page provides an array of blank touchscreen buttons that can be programmed as
macros. (See ‘Recording Macros’ on page 28 in your Avidea Remote Control Setup and Use Guide.)
: Controlling the AM/FM Tuner From the Avidea Control Center
You can control the Tuner using the buttons on the Control Center or with your Avidea Remote
Control. The Control Center buttons provide basic operation of the Tuner. Here are the functions
of the Control Center buttons.
Rev (Tuner)
Selects the next Tuner preset down from the last preset chosen. Goes to
the previous bank after first preset within a bank. Starts from preset A1
if preset tuning has not been previously used.This will occur even if
there are no stations stored in any preset.
Fwd (Tuner)
This works like the Tuner Rev control, but in the forward direction.
.
.
.
.
.
.
. . .
. . .
OPERA
TION
34
Tuner Listen
The second LCD page provides touchscreen buttons to select the Listening Mode as either stereo
or surround music, and provides 5 or 6 speaker control. There are also controls for the Status Bar,
the Control Center Display, as well as the subwoofer volume. (See ‘Listening Modes’ on page 36
for more details.)
Tuner Preset
The third LCD page provides touchscreen buttons for storing and recalling Tuner Presets.
(1) Press “store preset” to begin storing a preset. Go to LCD page one or four to tune to the
desired frequency. Return to this LCD page.
(2) Press A, B, or C to select a preset bank.
(3) Select 1–9 to select a preset number.
(4) Press “store preset” to finish storing a preset.
(5) The Control Center displays “Preset Stored.”
x
Note : If more than 5 seconds passes between any step in the process, the action is cancelled.
To recall a stored preset using this LCD page, press the bank and preset number.
Adjusts the amount of bass coming
from the Avidea Subwoofer
Displays the Avidea Status Bar
Uses 5 or 6 speakers for
music listening
Turns the rear center speaker
on and off
Turns off all Avidea Control Center
lights except Power, and allows
only basic operation. Press again
to restore lights
Uses only the front left and front
right speakers
Numbers used to select/store
a preset number
Begins/ends the store
preset process
Selects/stores A, B, or C
preset bank. Each bank
holds up to 9 presets
Selects FM band
Switches FM band to Mono
Numbers used to select station
frequency
Tunes selected frequency
Selects AM band
35
OPERA
TION
OPERATION
03
SECTION
03
SECTION
OPERATION
