Bostitch GCN40T, Руководство по безопасности и эксплуатации

Страница: 19 / 240

A Length mm. K Magazine capacity
B Height mm. L Working Ambient Temprature
C Width mm. M Charger Ref
D Weight Kg. N Input Power Source
E Noise LPA 1s d O Charging Time in Minutes at 20ºc (70f)
F Noise LWA 1 s d P Charging Voltage
G Vibration m/s2 Q Charging Current
H Fastener Name R Weight Kg.
I(a) Dimensions mm. S Battery Weight Kg.
I(b) Dimensions mm. T Battery Type
J Head/crown U Fuel Cell - Liquid Hydrocarbon:propane/butane
Operator troubleshooting
PROBLEM CHECK METHOD CORRECTION
Nailer operates, but no nail is driven. Check for a jam. Clear the jam.
Check function of the nail feeder. Clean and lubricate if required.
Ribbon spring weakened or damaged? Replace ribbon spring.
Check the correct nails are being used. Use only recommended nails.
Check if the driver blade piston is Remove the battery, fuel cell & nails from the tool
not returned to the top position and, using a thin piece of metal of screwdriver
100mm long (not included), insert into the contact
arm (Fig 58) and push the bar to the top position.
Skipping nails. Check for proper nails. Use only recommended nails.
Intermittent feed. Check function of nail feeder. Clean and lubricate.
Ribbon spring weakened or damaged? Replace ribbon spring.
Nail feeder worn or damaged? Replace nail feeder.
Check for returning of piston. Pull the trigger firmly and for about 0.5 sec after combustion.
Too low temperature, warm up
fuel cell under 50°C (120°F).
Check for moving of piston smoothly. Contact Bostitch for replacement.
Replace piston ring.
Replace piston.
Replace cylinder piston ring.
Nails jam. Check for proper nails. Use only recommended nails.
Driven nail is bent. Driver blade worn? Contact Bostitch for replacement.
Nail feeder worn or damaged? Replace nail feeder.
The operation of the contact arm Contact arm bent? Contact Bostitch for replacement.
not smooth. Check contact arm’s moving track for Contact Bostitch for replacement.
debris.
Fan is working, light indicator Check for returning of piston. Push the contact arm all the way.
shows GREEN yet it doesn’t drive Too low temperature, warm up
a nail or operation unstable. fuel cell under 50°C (120°F).
Check fuel cell, insufficient? Exchange it with a new fuel cell.
Check spark plug wire, worn out? Contact Bostitch for replacement.
Check spark plug, grease or debris? Contact Bostitch for replacement.
Check filter, clogged? Clean in accordance with the
maintenance chart.
Fan does not operate when push Magazine empty. Load more nails in the magazine.
lever is pressed. Note the color of the light indicator. If red: charge the battery.
If green: Contact Bostitch for replacement.
Unable to charge battery. Check the electrical cord.
Technical Data Table Key (See page 2)