Boss Dr. Rhythm DR-880, Руководство пользователя

Страница: 107 / 168

107
Editing a kit
Chap. 7
■
PAD (Edits for each key
pad (Pad Parameters))
fig.06-040d
To select the key pad you want to edit, proceed
as follows:
1.
Press [PAD] to switch the pad bank.
2.
Press the desired key pad 1–20.
Parameter/
Range
Explanation
Inst
see p. 151
Select the sound (instrument) as-
signed to the key pad
Level
0–100 Adjust the volume of the instrument
Pan
L50–CENTER–
R50
Adjust the panning
* This is valid if Out Assign is set to MASTER, IFX
(OTHERS), or IND. A+B
* If Out Assign is set to IFX (KICK/SNARE), use the
reverb send level of the insert effect (p. 108) to make
adjustments.
Rev.Send
0–100
Depth of reverb applied to each in-
strument
* This is valid only if Out Assign is set to MASTER.
Out Assign
see below
Select the output destination for the
sound of each instrument, or the in-
sert effect to be used
MASTER:
The sound will be output from the MASTER OUT jacks
without being processed by an insert effect.
IFX (KICK):
The sound will be processed by the Kick insert effect.
The output destination will be as specified by the Out
Assign setting of the insert effect (p. 108).
IFX (SNARE):
The sound will be processed by the Snare insert effect.
The output destination will be as specified by the Out
Assign setting of the insert effect (p. 108).
IFX (OTHERS):
The sound will be processed by the Others insert effect.
The output destination will be as specified by the Out-
put Assign setting of the insert effect (p. 108).
IND. A:
The sound will be output from the INDIVIDUAL A
jack.
IND. B:
The sound will be output from the INDIVIDUAL B
jack.
IND. A+B:
The sound will be output from both INDIVIDUAL A
and B jacks.
Mute Group
OFF, 1–31
Specifies how the unit is to sound
when you play consecutive notes
with one or more instruments
OFF:
When you play instruments consecutively, the previ-
ous sound will continue while the newly played sound
is heard.
1–31:
Instruments that are set to the same Mute Group num-
ber will not sound simultaneously. This is typically
used for instruments that cannot normally sound at the
same time, such as open hi-hat and closed hi-hat.
Pit. Coarse
-50 –0–+50 Coarse pitch adjustment
+ values:
The greater the value, the higher the pitch. A setting of
+1 raises the pitch one semitone.
0:
The instrument will sound at its original pitch.
- values:
The greater the value, the lower the pitch. A setting of -
1 lowers the pitch one semitone.
* On some instruments, the pitch may not change correctly
for positive (+) settings.
Pitch Fine
-50–+50 Fine pitch adjustment
Decay Time/ Rel. Time/Decay Lev
0–127
These parameters specify how the
volume changes over time, from
when the instrument is played until
the sound decays to silence. This is
referred to as the “envelope.”
Parameter/
Range
Explanation