Boss Snowplow VBX 6500, Руководство пользователя

Страница: 11 / 32

Building and Installing the
Spacer
1. Measure the distance from the front of the truck
box to the spreader legs.
2. Using 3.8 x 18.4 cm (1–1/2 x 7–1/4 inch) lumber,
build the spacer as shown in
Figure 9 .
g036953
Figure 9
1. Distance between the
spreader leg and the truck
box 3. 57.7 cm (22–3/4 inches)
2. Distance between the
truck box and the take-up
housing 4. Width of the truck box
3. Insert the spacer between the spreader and the
front of the truck box.
Securing the Spreader
DANGER
The spreader is heavy and could cause
serious injury or property damage if it falls
off the vehicle.
Ensure that the ratchet straps are securely
attached to the spreader at all times.
1. Connect the ratchet straps to the D-rings around
the upper edge of the spreader (
Figure 10 ).
g029491
Figure 10
1. D-ring 2. Ratchet straps
2. Cross the straps near the vehicle cab and attach
them to the D-rings opposite to them on the
truck bed (
Figure 10 ).
3. Attach the straps near the rear of the vehicle
to the D-rings nearest them on the truck bed
(
Figure 10 ).
4. Tighten the straps evenly to secure the spreader.
Installing the Spinner
Assembly
1. Attach the adjustment assembly to the spinner
assembly using 2 flat washers (5/16 inch) and
4 thumb screws as shown in
Figure 11 . Tighten
them 1/4-turn past finger-tight.
11